Home > News > Content
Cold Resistant Conveyor Belt To Ensure Full Volatilization Of Solvents
Jul 12, 2017

Cold Resistant Conveyor Belt joints in the process, two fierce sometimes according to the bonding process after all the process, will also find the joint did not stick, peel off the joint, found that adhesive layer no sticky, adhesive surface hard, shiny, this is "dry overdo" phenomenon. This is in the process of drying or baking the glue, in order to ensure the full evaporation of solvents, to ensure that the glue layer of the complete curing, too much prolonged drying or baking time, so that the adhesive has been completely cured or fast and complete curing, so that the two layers of adhesive surface intermolecular Force and chemical force becomes very small, resulting in joint adhesion. This requires us to dry or bake, according to the site temperature, weather, such as the actual situation, control the appropriate time, not only to ensure the infiltration of Cold Resistant Conveyor Belt solvent volatile, but also to make the adhesive layer, to ensure that the first time the plastic fully dry, pay attention to the second time, the third time glue drying to Non-stick hand and have a sticky feeling can be bonded.

Check the misalignment of the longitudinal centerline of the roller and the belt conveyor. If the value of the non coincidence is over 3mm, it should be adjusted using the long mounting holes on both sides of the Idler group. The specific method is to which side of the Cold Resistant Conveyor Belt is biased, which side of the Idler group moves forward toward the conveying belt, or the other side moves back. Check the deviation value of the two planes of the bearing seat of the head and tail rack. If the deviation of the two planes is greater than 1mm, the two planes should be adjusted in the same plane. The head Drum adjustment method is: if the conveyor belt to the right side of the drum, then the right side of the roller bearing seat should be moved forward or the left side of the housing shift; if the Cold Resistant Conveyor Belt to the left side of the drum, then the left side of the roller bearing seat should be moved forward or the right The adjustment method of the tail roller is just the opposite of the head cylinder. Check the position of the material on the conveyor belt. The material in the conveyor belt cross section is not centered, will cause the Cold Resistant Conveyor Belt to run slants.

Cold Resistant Conveyor Belt is no exception, their maximum aging ratio is 88, the performance of the tensile aging after a lot of decline, only 40% of the level. In this way, performance is greatly reduced. Among them, the steel network high temperature conveyor belt is made of high temperature resistant materials and steel wire, steel wire surface will be plated with metal, and then covered with a layer of high-temperature rubber, the formation of high temperature resistance steel wire Cold Resistant Conveyor Belt. High-temperature steel wire conveyor belt reliability greatly improved, the surface will not occur back layer phenomenon, compared to the simple high-temperature conveyor belt to be more stable. The production of Cold Resistant Conveyor Belt of the glue has a difference, different rollers manufacturers of the formulation of the glue must have a slightly different. Can the products sold by different conveyor belts be mixed? This is not too much to say, because here, and the different delivery of the production process, said the simple point is that the roller formula is not necessarily the same as a result.